The Easylite ILS. The Easylite Integrated Lighting System offers economical dimming and scheduled on-off control of general building fluorescent lighting through low voltage control. All Easylite ballasts are 'dimming' with the capability to proportionally control the lamp output from 100% down to 10%. The Easylite ILS system includes: dimming ballasts, low voltage local dimmers, daylight harvesters, occupancy sensors, pre-terminated plug-in control cabling, and scheduling software or seamless interoperability with all building automation systems.

Start with the Ballast, it provides low voltage power for the entire system. Easylite's patented ballasts are the foundation of the Easylite ILS. Easylite ballasts offer proportional dimming and low voltage on/off control, and they provide the low voltage power needed to run the Easylite ILS and all its controls. T8 Parallel Dimming Ballast >

Use Plug and Play low voltage cable. Easylite ballasts use pre-terminated, plenum rated cable with RJ-11 connectors to channel low voltage power to Easylite controls, and to the lighting system control loop. Low Voltage Cable >

Add one dimmer switch, or ten, per room. To control the dimming and on/off capabilities inherent in Easylite ballasts, plug in a low voltage Decora style Touch Dimming Switch, in a single location, or plug in up to ten independent dimming switches per room. Touch Control Dimmer >

Respond to daylight: enjoy the savings. Easylite's Daylight Harvester senses ambient light 24/7, and dims the fixtures to maintain a target light level. Running on ballast provided low voltage power, one Daylight Harvester can control up to 100 Easylite ballasts. Everytime you dim, you save energy. Daylight Harvester >

Sense occupancy: only pay for the light you need. Easylite offers a variety of ballast powered occupancy sensors for use in Office Buildings, Warehouses, Healthcare and Educational institutions. Easylite Occupancy Sensors >

Schedule non-dimming loads: control any load on a 20 Amp circuit. Easylite's Power Switch Relay (PSR) module allows for low-voltage on/off control of any 20 Amp AC circuit. With the PSR, you can provide on/off control of either fluorescent or incandescent lighting circuits using software, or any Easylite local control device. With an Easylite PSR, you can control a few fixtures, or an entire circuit, from your computer, on schedule, or in real time. Power Switch Relay (PSR) >

Split large lighting zones into smaller sub zones. Split larger Zone Controller lighting zones into smaller sub zones using the Link-Easy sub zone controller. Link-Easy >

Interface with your Emergency / Egress Lighting System. Easylite's Emergency and Egress fixture controllers allow your Easylite ILS to control your Emergency and Egress fixtures. Emergency Module >

No existing Building Automation System? No problem. Run your Easylite ILS manually, using a timer, or use EasyTalk. EasyTalk is stand-alone lighting energy management system embedded in a dedicated computer. Each EasyTalk system has a unique IP address, so all of your Easylite ILS controls are accessible using an ethernet network, the World Wide Web, or a separate computer. EasyTalk >

Split your lighting into individually addressable zones. Easylite ILS uses pre-terminated low voltage cable to connect fixtures and create lighting zones. Using one Easylite Zone Controller, you can control four independent lighting zones with up to 250 fixtures per zone. Want to scale up your ILS? Just use our plug and play low voltage cable to connect up to 64 Zone Controllers for a total of 256 independently controlled lighting zones. Zone Controller >